Change Awning Roller

If a new roller cover assembly is being installed a 1 8 hole will need to be drilled 1 1 2 to 2 from end of the main slat for the pop rivets.

Change awning roller.

Flip it just like you would when fully extending the awning. Use the awning rod to pull the awning away from the rv by 1 foot 30 cm. This is because the lights will be covered by the unrolled awning fabric if it s not fully extended. Rv awning replacement fabric will fit awnings that use a 1 4 size rope at the awning rail almost all use this and will fit a range of roller tube rope sizes 5 32 3 16 1 4 rope sets included.

For more information call 5. Special discount for rvgeeks viewers. You can easily replace your old beat up worn torn roll up awning fabric without replacing the hardware. The end of the awning you will only be able to use the lights when the awning is fully extended.

Flip the control lever to extend the awning by 1 foot 30 cm. Now use the awning rod to pull the roller tube out about 1 foot 0 30 m from the rv. Our universal 13 oz. Start by flipping the control lever on the right side of the roller tube as though you re preparing to fully extend the awning.

Check that both arms are resting on the ground so that the fabric is unrolled about 1 foot 0 30 m from the awning. Installing on the rv awning roller end of the awning if you install your rv awning lights along the awning roller i e. Find the control lever on the right side of the awning s roller tube.